Fence and gate lighting: LEDs, sensors, power supply
Fence lighting is planned before installation, together with the cable route, because once the paving is down every change means breaking it up. Below: which posts to light, LEDs in the posts or wall lights, what voltage and IP rating the fittings need, what colour temperature to choose, and what to do if the surface has already been laid.
Where to put the lights
You don’t need to light everything. Three places work best: the driveway and pedestrian gate posts (orientation and a safe entrance), the house number and intercom (so visitors and couriers can find you), and every second or third post along the frontage, to create a rhythm. Lighting every single post makes it look like a runway.
LEDs in the posts or wall lights
Posts with factory-fitted LED lighting give the cleanest result: the cable runs inside, nothing sticks out, and the light falls downwards onto the surface. Up-and-down wall lights create a striking ‘strip of light’ on a masonry post or gabion. On aluminium and steel fences, an LED in the post looks like part of the system; a wall light looks like an add-on.
Dusk sensor, motion sensor or app
A dusk sensor is the basic option: the lights come on by themselves. A motion sensor at the pedestrian gate and driveway is a good addition (brighter when someone approaches). App control makes sense if the house already has a smart home system. In most homes a dusk sensor and a switch in the hallway are enough.
What to do before installation
- Run a cable duct from the building along the fence line before the paving and lawn go in.
- Mark on the fence drawing which posts are to be lit. The manufacturer will prepare them at the factory, with cable entry grommets.
- Plan a place for the power supply in the house (garage, boiler room) and a circuit breaker in the consumer unit.
Colour temperature and brightness
Two decisions change the result most: colour temperature and intensity. Fences and house façades are better suited to warm light (approx. 2700–3000 K): it brings out anthracite and stone, doesn’t ‘bleach’ the façade and doesn’t dazzle the neighbours. A cool colour temperature (4000 K and above) looks like car-park lighting and clashes with the warm light from the windows.
You need less output than you might think. LED points in the posts are there to mark the line of the fence and light up the surface. A few watts per post is enough, with more only at the driveway and pedestrian gates. The motion sensor needs to be set so that it doesn’t react to cars passing in the street, otherwise the lights will flicker on and off all night.
Frequently asked questions
Can the LEDs in the posts be replaced if they fail?
In good systems the LED module can be replaced without dismantling the post. Before ordering, check the product data sheet to see whether the module is replaceable and whether the manufacturer keeps it in its range. A few years down the line, this decides whether a repair means replacing a module or the whole post.
Does fence lighting need a qualified electrician?
Connection to the 230 V installation (power supply, circuit breaker in the consumer unit) is carried out by a qualified electrician. The low-voltage cabling between the power supply and the posts is run in a cable duct when the fence is installed, but connecting and testing the whole system is the electrician’s job.
How do I power the lighting if the paving is already down?
Sometimes the cable can be run in the joints or in a conduit along the kerb, or the section can be powered from a nearby garden light. These are compromises, which is why a cable duct laid before the surface goes down is cheaper than any of these fixes.
Quote after a site survey
We’ll come out for a site survey and prepare a quote within 7 working days of it. There is a charge for the site survey because it covers travel, measurements including levels, and choosing the system; the cost is agreed individually and deducted from your order. Manufacturer’s warranty – Wiśniowski fences come with an anti-corrosion warranty of up to 10 years. The terms of our own installation warranty are set out in the quotation.
Request a quote