Fences along the road: visibility, distance and the gate
A fence up to 2.20 m high along the road can be built without a notification (zgłoszenie), just like one between neighbours. The differences lie elsewhere: driveway and pedestrian gate leaves should not swing out over the pavement or carriageway, the posts must stand outside the road corridor (pas drogowy), and the local zoning plan (MPZP) often limits the height and requires gaps on the street side. Below are the rules for plots in Piaseczno, Konstancin-Jeziorna, Lesznowola and Góra Kalwaria.
Gates open inwards
We install driveway and pedestrian gates so that they open inwards into the plot. We do not use sharp elements (barbed wire, broken glass) below 1.8 m. What changed in the technical regulations in 2026 is covered in the post What the rules say about fences in 2026. A leaf that opens onto the pavement or carriageway puts pedestrians and cyclists at risk. What this means for each type of gate:
- Double swing gate: the leaves open into the property. If the driveway rises towards the house, the leaves catch on the surface. In that case, choose a sliding gate or level the strip under the leaves.
- Sliding gate: the cantilever leaf slides along the fence on the property side and does not enter the road corridor. It needs run-back space of approx. 1.5 × the clear opening width (for a 4 m entrance: approx. 6 m along the fence).
- Pedestrian gate: opens inwards. We set the width at the site survey; most often 1.0–1.2 m clear width.
Visibility at the driveway exit
A tall, solid fence on the corner of a plot at a junction or on a bend limits visibility for drivers pulling out of the property and for those driving along the road. There is no general rule on visibility at fences. Requirements may be set by the local zoning plan (often as a cut-off corner of the plot at a junction, known as a visibility splay) or by the road authority, i.e. the municipality (gmina) for municipal roads and the county (powiat) for county roads. The road authority also issues the permit for the location of the driveway access and may attach visibility conditions to it.
The local zoning plan
Local zoning plans (MPZP) in municipalities near Warsaw (Piaseczno, Konstancin-Jeziorna, Lesznowola, Góra Kalwaria) often contain provisions on fences along roads: a maximum height (e.g. 1.8 or 2.0 m), a ban on solid fences or a minimum gap requirement (e.g. 30–50% open area), a ban on precast concrete fences at the front, and sometimes a requirement to place the fence on the road’s boundary line as drawn in the plan, which may be set back from today’s edge of the carriageway because the plan reserves land for widening the road. Each plan has its own provisions, so check the one for your specific plot: on the municipality’s geoportal or at its spatial planning department.
If there is no plan, a zoning decision (warunki zabudowy) is usually not issued for a fence up to 2.20 m. What counts then is the municipality’s landscape resolution (uchwała krajobrazowa) and the requirements of the heritage conservation officer (konserwator zabytków), if the area is protected.
The road corridor and the plot boundary
A fence is built on your own plot, even if ‘everyone on the street has their fence right up against the tarmac’. The carriageway, pavement, verge and ditch make up the road corridor, which belongs to the road authority. On the road side, the plot boundary can lie tens of centimetres back from the kerb. The road authority can order a post standing in the road corridor to be removed. If in doubt, a surveyor re-establishes the boundary markers. That is a small cost compared with moving a fence.
Neighbour-side and road-side fences: the differences
| Issue | Fence between neighbours | Fence along a public road |
|---|---|---|
| Notification (zgłoszenie) | Above 2.20 m | Above 2.20 m (since 28 June 2015, the same as between neighbours) |
| Gate opening direction | Inwards into the plot (how we install) | Inwards into the plot (how we install); the leaf does not swing out over the pavement |
| Visibility | Not applicable | No general rule; requirements may be set by the local zoning plan or the road authority |
| The local zoning plan | Rarely covered | Often: height, gaps, material, road boundary line |
| Position | On your own plot, or on the boundary line with the neighbour’s consent | Only on your own plot, outside the road corridor |
| Sharp elements | We do not fit them below 1.8 m | We do not fit them below 1.8 m |
Example: a corner plot
Example: a corner plot in Lesznowola at a junction of municipal roads, with 1.9 m solid slats along the whole frontage. The local zoning plan allows 2.0 m, so the height is fine. The problem is the corner: the solid slats block the view of the junction. The solution: the last 3 m before the junction with 5 cm gaps instead of 2 cm, and the panel lowered to 1.5 m. The fence looks as if it was designed ‘with a gradient’, and a driver pulling out of the property can see oncoming cars.
Frequently asked questions
Can a gate open onto the pavement if the pavement is wide?
We don’t install gates like that. Whatever the width of the pavement, the leaves open inwards into the plot or the gate slides along the fence. An open leaf on the pavement blocks the way and puts pedestrians at risk.
How do I check whether my plot is covered by a local zoning plan?
On the municipality’s geoportal (Piaseczno, Konstancin-Jeziorna and Lesznowola each have their own) or at the spatial planning department of the municipal office (urząd gminy). You check the plan and the landscape resolution with the municipality; a notification for a fence higher than 2.20 m is submitted to the county office (starostwo).
Who can make me lower my roadside fence?
Building control (nadzór budowlany), if the fence breaches the regulations or the local zoning plan, and the road authority, if the posts stand in the road corridor or the fence does not meet the conditions of the driveway access permit.
Sources
Legal position as of October 2026. General information, not legal advice.
Quote after a site survey
We’ll come out for a site survey and prepare a quote within 7 working days of it. There is a charge for the site survey because it covers travel, measurements including levels, and choosing the system; the cost is agreed individually and deducted from your order. Manufacturer’s warranty – Wiśniowski fences come with an anti-corrosion warranty of up to 10 years. The terms of our own installation warranty are set out in the quotation.
Request a quote