Call: +48 22 266 25 58
Wiśniowski winter promotion: garage doors with openers up to −25%, fences and doors up to −15%, orders by 31 DecemberGarage doors up to −25% · until 31 DecemberDetails ›
Home › Blog › When to choose a solid fence
Choosing

When to choose a solid fence

25 June 2026 · updated 6 October 2026 · 4 min read · Ogrodzenia ISS

A solid fence makes sense on the street side and wherever living-room windows or a terrace look straight out onto the pavement or the neighbours. Run all the way round the plot, it takes away light and air, and it loads the posts like a sail. Below: which infills give privacy (slats with narrower gaps, louvred slats, solid panels with concealed posts), how to deal with wind and what to check in the local zoning plan (MPZP).

Solid and louvred slats

The most common solution is a narrower gap between the slats, or slats set at an angle, known as louvred slats. From street level you cannot see into the property, yet the fence still lets light and air through, so it doesn’t look like a solid wall.

Panels with concealed posts

Aluminium systems (e.g. Alfen) allow long, solid panels with a concealed post, up to 6 m wide. The post sits behind the face of the panel, so from the street you see a smooth, continuous wall with no divisions.

A common layout: solid panels facing the street, open ones facing the garden. Same system and colour, different infill, so the whole fence looks like one design and the garden doesn’t lose light.

Regulations and the local zoning plan

A fence up to 2.20 m high (measured from ground level to its highest point, including posts and caps) needs neither a building permit nor a notification (zgłoszenie), including on the road side. A higher fence must be notified to the county office (starostwo) – for Piaseczno, that is Starostwo Powiatowe w Piasecznie; the county head (starosta) has 21 days to object. However, the local zoning plan (MPZP) or the municipality’s landscape resolution (uchwała krajobrazowa) may restrict solid fences: require gaps, limit the height of the solid part or ban precast concrete on the street side. There is no general rule on visibility at driveway exits or corners; requirements may be set by the local zoning plan or the road authority. Gates open inwards into the plot, and we do not fit sharp elements (barbed wire, broken glass) below 1.8 m. More on the formalities in a separate post: notification or permit.

Matching infill for the driveway and pedestrian gates

The driveway gate and pedestrian gate should have the same infill as the panels: a solid gate with a solid fence, otherwise an open leaf across a 4–5 m entrance exposes the inside of the property. A solid sliding gate has a heavier leaf and a greater wind load, so the motor is chosen to suit the leaf weight according to the manufacturer’s data sheet.

Wind and light with a solid fence

A panel with no gaps is a sail. Compared with an open panel, the wind load is several times higher, and dense slats with small gaps load the posts almost as much as a solid panel. The design has to allow for this: closer post spacing (usually up to approx. 2–2.5 m with solid infill), foundations at least down to the frost line (1.0 m for Piaseczno), and sometimes posts with a larger cross-section. So a solid fence needs to be calculated rather than built by eye.

The second issue is light and air. A tall, solid fence on the south side can put a narrow garden in shade and cut off the breeze to the terrace. Often a better option is solid infill only at eye level (louvred or solid slats up to approx. 1.6 m) with a gap at the top or bottom: you keep the privacy and the garden still gets light. An overview of infills is in the section on solid and slatted fence systems.

In short: solid panels facing the street and by the terrace, open ones along the garden and the boundary with woodland; posts at approx. 2–2.5 m centres on foundations down to the frost line; driveway and pedestrian gates in the same infill; check the local zoning plan with the municipality before ordering.

Frequently asked questions

Which is more discreet: louvred slats or a solid panel?

Louvred slats block the view from street level but let light and air through. A solid panel gives complete screening, but it looks ‘heavier’ and is more exposed to wind. The two are often combined on different stretches of the same plot.

Does a solid fence reduce traffic noise?

A little: mainly the high frequencies and the feeling of being on show. Real noise reduction requires mass (a wall, an acoustic barrier). An aluminium fence makes things more comfortable, but it is no substitute for a noise barrier.

Legal position as of October 2026. General information, not legal advice.

Quote after a site survey

We’ll come out for a site survey and prepare a quote within 7 working days of it. There is a charge for the site survey because it covers travel, measurements including levels, and choosing the system; the cost is agreed individually and deducted from your order. Manufacturer’s warranty – Wiśniowski fences come with an anti-corrosion warranty of up to 10 years. The terms of our own installation warranty are set out in the quotation.

Request a quote