Call: +48 22 266 25 58
Wiśniowski winter promotion: garage doors with openers up to −25%, fences and doors up to −15%, orders by 31 DecemberGarage doors up to −25% · until 31 DecemberDetails ›
Home › Blog › A fence on a slope: stepped or raked panels
Installation in practice

A fence on a slope: stepped or raked panels

10 November 2025 · 3 min read · Ogrodzenia ISS

Sloping plots are commonplace around Piaseczno, Konstancin and Góra Kalwaria. There are two ways to install a fence on them: level panels with a fixed step at each post (stepping), or panels made to measure to follow the angle of the slope. Below: when to use which, what to do about the plinth and posts, and where to put the driveway and pedestrian gates on a slope.

Stepping

With aluminium and steel fences made from ready-made panels, stepping is the most common approach: each panel is level and the next one is set lower or higher by a fixed ‘step’. On a gentle slope the steps are barely noticeable. On a steep one they become part of the rhythm, which only looks good if the step is the same along the whole length.

Raked panels

Panels matched to the angle of the slope give a continuous, sloping top line. They look natural with horizontal slats, but they cost more (made to measure) and not every system offers them. They make sense on long, even slopes. On irregular ground, stepping looks calmer and costs less.

With stepping, the bottom edge of the panel must not be left ‘hanging’. The gap under the panel is closed off with a plinth or a concrete strip stepped along with the fence. Otherwise you get a tunnel for the dog under the fence and a spot where rubbish collects.

A plinth on a slope

A system plinth (concrete gravel boards between the posts) is also stepped on a slope: each segment level, with a step at the post. On steeper slopes a masonry or poured concrete plinth works better, following the slope, with the panels stepped above it. On a slope, the decision about the foundation matters as much as the choice of design.

Posts on the lower side

On a slope, posts on the lower side have less soil ‘behind’ them and are subject to a greater bending moment from the wind. That is why they are anchored deeper and in wider foundations than on level ground. You can’t see it once the fence is up, but it decides whether the fence is still standing straight after a few winters.

Site survey on a slope

On a slope, as well as the length of the frontage, levels are taken along the whole length of the run. Only from this data are the post spacing (so that the steps come out even) and the height of each segment of the plinth worked out. On a slope, the top line of the fence affects the look more than the colour does.

Driveway and pedestrian gates on a slope

A cantilever sliding gate moves horizontally, so the run-back strip along the fence (approx. 1.5 × the clear opening width, i.e. approx. 6 m for a 4 m entrance) must be level. If this stretch is on a slope, the surface is levelled or a double swing gate is chosen instead. The leaves always open inwards into the plot. If the ground rises towards the inside, the leaves would catch on the ground, so a sliding gate is the better option, or the strip under the leaves is levelled. The decision is made once the slope has been measured along the centre line of the entrance and along the fence.

On a slope, the pedestrian gate is placed at the highest or lowest point of the run, never halfway along a step. That way the threshold is flush with the surface and the leaf doesn’t catch on the ground when it opens. Steps or a ramp up to the gate need to be planned from the start, together with the fence. Added later, they look worse and rarely line up with the threshold.

Frequently asked questions

Is a fence on a slope more expensive?

Usually, yes: more posts with stepping, deeper foundations on the lower side and sometimes a made-to-measure plinth. The difference depends on the gradient and only becomes clear in the quote after a site survey that includes levels.

What about drainage for a fence on a slope?

A plinth or concrete strip footing on a slope must not act as a dam for water running down the hillside. Openings are left at the lowest points so that water doesn’t undermine the foundations from the uphill side.

What is the ideal step height for stepping?

One that repeats evenly along the whole run, usually 10–25 cm depending on the gradient. It is chosen together with the post spacing so that the top line has an even rhythm.

Quote after a site survey

We’ll come out for a site survey and prepare a quote within 7 working days of it. There is a charge for the site survey because it covers travel, measurements including levels, and choosing the system; the cost is agreed individually and deducted from your order. Manufacturer’s warranty – Wiśniowski fences come with an anti-corrosion warranty of up to 10 years. The terms of our own installation warranty are set out in the quotation.

Request a quote